Difference between revisions of "FTC Hardware Tips and Techniques"
From wikidb
JohnDelacy (Talk | contribs) |
(→Schedule) |
||
Line 12: | Line 12: | ||
== Schedule == | == Schedule == | ||
− | * | + | * 6:00 pm Wednesday September 17, 2008 at OMSI |
== Prerequisites == | == Prerequisites == |
Revision as of 22:27, 4 September 2008
Owner
John DeLacy Assisted by Ian McBride
Goals
- Get coaches started with the FTC mechanical and electrical components.
- Highlight potential problems and pitfalls.
Schedule
- 6:00 pm Wednesday September 17, 2008 at OMSI
Prerequisites
FTC Getting Started with C or FTC Getting Started with NXT G
Outline
- Tips and tricks
- Hole pattern allows connecting at various angles (OK, 45, 90, 135, 180 deg.)
- Counterweights are hard to make
- Parallelagram arms look good
- Connecting Lego and Tetrix together
- What can go wrong
- Supporting servos and motors
- Need low center of gravity
- Battery management and electrical issues
- Recharging batteries - get a quick charger
- Watch for shorts
- Use heat-shrink tubing if allowed (check this)
- Careful cable routing - cables are rather stiff